home *** CD-ROM | disk | FTP | other *** search
- .AP.SP 2
- .PS 60,70
- Kermit-10 now has a lot of patches put into it. The first set of
- patches is based on those submitted by PIMA. The subsequent patches are
- added in order to make Kermit-10 similar to Kermit-32. The last patch is
- to change all the search file names to K10??? as opposed to KER???.
- .B 2
- .HL 1;PATCH [127]
- Based on the patches we received from PIMA the following changes have
- been added to KERMIT and KERUNV.
- .B.LS
- .LE;Fix IFN stopcode if syntax error in KERMIT.INI.
- .LE;Add help text for connect mode ESCape commands.
- Q (Quit) and R (Resume) logging
- .LE;Add SET XON-XOFF-PROCESSING to determine how Xon/Xoff should be handled
- during connect.
- .LE;Add a new File Byte Size of 36-Bits for 10/20 transfers
- .ELS.B
- These changes are in Modules KERMIT and KERUNV
- .b
- .HL 1;PATCH [130] _& [3_.1_.045]
- When attempting to do multiple file sends from Kermit-10, the prompt
- indicating subsequent sends is screwed up. It sends: the sent file name,
- followed by, "as ", "Sending: ", and then, the original file name. This is
- due to the timing of when NEXT__FILE prints the "Sending: " prompt.
- The fix is to take the subsequent file sending prompt out of KERMSG
- and put it into KERMIT. This fixes the problem, but it also requires
- a similar patch to be put into KERMIT-32 and PROKERMIT.
- .B
- Changes were to Modules KERMIT and KERMSG.
- .B
- .HL 1;PATCH [131], [132], _& [133]
- Make KERMIT-10 look similar to KERMIT-32. Alow KERMIT to set the IBM
- handshaking character, incase the IBM character is something other
- than _^Q. Fix the IBM macro defined to set up the three parameters
- required for IBM transfers, this means to add in the setting of the
- handshake character. The kludge use of IBM-MODE is no longer needed,
- remove it.
- .B
- The changes are in Module KERMIT
- .B
- .HL 1;PATCH [134]
- Since the distribution files for KERMIT-10 are changed to K10???.???,
- lets make the source file names that in the first place. This
- requires that all search file names must be changed to K10???. The
- prologue in K10UNV should remain as KERMIT or else you won't be able
- to find the help file for KERMIT. Also there is a new help file
- which contains the SET HANDSHAKE and SET XON-XOFF-PROCESSING help.
- The help file also modifies the the SET IBM-MODE command to SET IBM
- which initiates the IBM macro.
- .B
- These changes were done to ALL Modules.
-